LM5145 datasheet(20/55 Pages) TI

20 / 55 page

8.3.6 Switching Frequency (RT, SYNCIN)

There are two options for setting the switching frequency, FSW, of the LM5146, thus providing a power supply

designer with a level of flexibility when choosing external components for various applications. To adjust the

frequency, use a resistor from the RT pin to AGND, or synchronize the LM5146 to an external clock signal

through the SYNCIN pin.

8.3.6.1 Frequency Adjust

Adjust the free-running switching frequency by using a resistor from the RT pin to AGND. The switching

frequency range is from 100 kHz to 1 MHz. The frequency set resistance, RRT, is governed by Equation 3. E96

standard-value resistors for common switching frequencies are given in Table 8-1.

kHz

(3)

Table 8-1. Frequency Set Resistors

SWITCHING FREQUENCY

(kHz)

FREQUENCY SET RESISTANCE

(kΩ)

100

200

49.9

250

40.2

300

33.2

400

24.9

500

750

13.3

1000

8.3.6.2 Clock Synchronization

Apply an external clock synchronization signal to the LM5146 to synchronize switching in both frequency and

phase. Requirements for the external clock SYNC signal are:

• Clock frequency range: 100 kHz to 1 MHz

• Clock frequency: –20% to +50% of the free-running frequency set by RRT

• Clock maximum voltage amplitude: 13 V

• Clock minimum pulse width: 50 ns

1 Ps/DIV

SYNCIN

2 V/DIV

SW 10 V/DIV

Figure 8-5. Typical 400-kHz SYNCIN and SW Voltage Waveforms

LM5146

SNVSBV0A – JUNE 2021 – REVISED JUNE 2021

www.ti.com

Submit Document Feedback

Product Folder Links: LM5146

LM5145 Folha de dados(PDF) 20 Page - Texas Instruments

LM5145 Folha de dados(HTML) 20 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Folha de dados Download

Ligação URL