MODEL: HAP

HAP SPECIFICATIONS

ES-3451 Rev.11 Page 1/4

http://www.m-system.co.jp/

Space-saving Plug-in Signal Conditioners H-UNIT

DC/FREQUENCY CONVERTER

Functions & Features

• Providing a pulse rate output in proportion to DC input

signal

• High-density mounting

Typical Applications

• Totalizing applications in combination with a counter

26 (1.02)

93

(3.66)

mm (inch)

137

(5.39)

MODEL: HAP–[1][2]–R[3]

ORDERING INFORMATION

• Code number: HAP-[1][2]-R[3]

Specify a code from below for each of [1] through [3].

(e.g. HAP-61-R/Q)

• Special input range (For codes Z & 0)

• Output frequency range (e.g. 0 – 500 Hz)

• Specify the specification for option code /Q

(e.g. /C01/S01)

[1] INPUT

Current

A: 4 – 20 mA DC (Input resistance 250 Ω)

D: 0 – 20 mA DC (Input resistance 50 Ω)

G: 0 – 1 mA DC (Input resistance 1000 Ω)

H: 10 – 50 mA DC (Input resistance 100 Ω)

Z: Specify current (See INPUT SPECIFICATIONS)

( 0 % input must be 0 mA.)

Voltage

3: 0 – 1 V DC (Input resistance 1 MΩ min.)

4: 0 – 10 V DC (Input resistance 1 MΩ min.)

5: 0 – 5 V DC (Input resistance 1 MΩ min.)

6: 1 – 5 V DC (Input resistance 1 MΩ min.)

0: Specify voltage (See INPUT SPECIFICATIONS)

( 0 % input must be 0 V.)

[2] OUTPUT

1: Open collector (max. 1 kHz)

2: 5 V pulse (max. 1 kHz)

5: Photo MOSFET relay pulse (max. 30 Hz)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[3] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

TERMINAL SCREW MATERIAL

/S01: Stainless steel

GENERAL SPECIFICATIONS

Construction: Plug-in

Connection: M3.5 screw terminals (torque 0.8 N·m)

Screw terminal: Nickel-plated steel (standard) or stainless

steel

Housing material: Flame-resistant resin (black)

Isolation: Input to output to power

Zero adjustment: 0 – 5 % (front)

Span adjustment: 95 to 105 % (front)

INPUT SPECIFICATIONS

■ DC Current:

Shunt resistor attached to the input terminals (0.5 W)

Specify input resistance value for code Z.

■ DC Voltage: 0 – 300V DC

Minimum span: 1V

Input resistance: 1 MΩ min.