X11SSL datasheet(21/124 Pages) ETC1

21 / 124 page

Chapter 1: Introduction

In addition to enabling operating system-directed power management, ACPI also provides a

generic system event mechanism for Plug and Play, and an operating system-independent

interface for configuration control. ACPI leverages the Plug and Play BIOS data structures,

while providing a processor architecture-independent implementation that is compatible with

Windows 7, Windows 8, and Windows 2012 Operating Systems.

1.6 Power Supply

As with all computer products, a stable power source is necessary for proper and reliable

operation. It is even more important for processors that have high CPU clock rates.

The X11SSM(-F)/X11SSL(-F) motherboard accommodates 24-pin ATX power supplies.

Although most power supplies generally meet the specifications required by the CPU, some

are inadequate. In addition, One 12V 8-pin power connection is also required to ensure

adequate power supply to the system.

Warning: To avoid damaging the power supply or the motherboard, be sure to use a

power supply that contains a 24-pin and one 8-pin power connector. Be sure to con-

nect the power supplies to the 24-pin power connector (JPWR1), and the 8-pin power

connector (JPWR2) on the motherboard. Failure in doing so may void the manufacturer

warranty on your power supply and motherboard.

It is strongly recommended that you use a high quality power supply that meets ATX power

supply Specification 2.02 or above. It must also be SSI compliant. (For more information,

please refer to the website at http://www.ssiforum.org/). Additionally, in areas where noisy

power transmission is present, you may choose to install a line filter to shield the computer

from noise. It is recommended that you also install a power surge protector to help avoid

problems caused by power surges.

1.7 Serial Port

The X11SSM(-F) motherboard supports two serial communication connections. X11SSL(-F)

supports COM Port 1 only. COM Ports 1 and 2 can be used for input/output. The UART

provides legacy speeds with a baud rate of up to 115.2 Kbps as well as an advanced speed

with baud rates of 250 K, 500 K, or 1 Mb/s, which support high-speed serial communication

devices.

X11SSL Folha de dados(PDF) 21 Page - List of Unclassifed Manufacturers