Appendix B

www.ti.com

14

SNAU228 – January 2018

Submit Documentation Feedback

Copyright © 2018, Texas Instruments Incorporated

USB2ANY Cable Connections

•

Interrupts: INT0, INT1, and INT2

The 10-pin cable is about 6 in long and has a keyed female 10-pin IDC connector on each end. Connect

the cable to the USB2ANY board as Figure 13 shows (note that the key must be facing up, away from the

board).

Figure 13. 10-Pin IDC Cable Connector

The opposite end of the cable is intended to be connected to the EVM or other target device. The red

stripe on the cable indicates pin 1.

Figure 14. 10-Pin IDC Cable Detail

Table 2. 10-pin Cable Pinouts

Schematic Pin Number

Cable Pin Number

Signals Available

J4-10

1

GPIO7, PWM0, INT2, OW2, OW5

J4-9

2

GPIO6, PWM1, RFFE:SCLK, SPI:CS, INT1, µWIRE:CS, OW1

J4-8

3

GPIO5, SPI:SOMI, UART:RXD, µWIRE:SOMI

J4-7

4

GPIO4, SPI:SIMO, UART:TXD, µWIRE:SIMO

J4-6

5

3.3VEXT

J4-5

6

GND

J4-4

7

GPIO3, PWM2, RFFE:SDATA, INT0

J4-3

8

GPIO2, ES:DOUT, SPI:SCLK, µWIRE:SCLK