OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.

Issue A.3 06/08

Page 2 of 2

OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006

Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com

OPA773 Dimensions

Power Line Designer Kit

OVPL5W3K

Remove adhesive backing

Place in desired position

Attach 28-26 gauge wires with tool #9175

OPA773

14-16 VOLT

DC INPUT

200mA min. per strip

- BLACK WIRE

+ RED WIRE

1.287 [32.68]

3.000 [76.20]

0.425 [10.79]

8.000 [203.20]

Optek Part Number

Number of LEDs per

Strip

Number of Strips

per Buss

LED Drive Current

per Strip

AWG

Supply

Voltage

OPA773 (included in kit)

3

1 to 5

125mA

26-28

14-16V

OPA775

3

1 to 30

125mA

18

14-16V

OPA776

3

2 to 60*

125mA

18

24V

Optek Custom Assembly**

Other

Other

Other

Other

Other

Suggested Design Options

1.

Install backplane (not included) behind panel to be

illuminated.

2.

Use masking tape (not included) to temporarily

position the boards on backplane.

3.

Route wire harness to each strip:

•

Start with loose end and work to-

ward 2.1mm jack.

•

Use insertion tool to insert red and

black wires on each board.

•

Leave several inches of slack be-

tween each strip.

4.

Connect the 2.1mm jack to 14-16V power supply

(not included, must be rated at 1.0A minimum).

5.

Reposition all boards until optimal illumination is

achieved.

6.

Peel tape backing from boards.

7.

Permanently apply boards to backplane.

Note: Steps 6 and 7 are optional—do not peel off

backing if the kit will be reused.

Instructions

*Multiples of 2 only

**Contact Optek or an authorized distributor to discuss your application.

3.000 [76.20]

Output connector

2.1mm ID/5.5mm OD

OVPL5W3K

OVPL5W3K