EVKT6532 DEMO BOARD

NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third

party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not

assume any legal responsibility for any said applications.

EVKT6532 Rev. 1.0

www.MonolithicPower.com

6

4/3/2018

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2018 MPS. All Rights Reserved.

QUICK START GUIDE

To quickly start using the EVKT6532 BLDC motor driver board, do the following:

1. Connect the U, V, and W wires of a BLDC motor to MOTOR connector. Connect the motor Hall

sensors to the HALL connector.

2. Connect a power supply (between 5V and 60V) to the VIN and GND pins.

3. Slide the DIR switch to “FWD” or “REV” to control the direction of the motor. Slide the “RUN/STOP”

switch to the right to run the motor. Slide the “BRAKE” switch to the right to apply short braking to the

motor.

4. Adjust the motor speed by turning the SPEED pot.

Note:

Please pay attention to the correct input polarity connection, to avoid damage due to

reversed connection.