MP6534 datasheet(6/6 Pages) MPS

Nome de Peças	MP6534

Descrição Electrónicos	5V to 55V, Three-Phase Brushless DC Motor Pre-Driver With Buck Regulator Evaluation Board

PDF	6 Pages

Scroll/Zoom	100%

Fabricante Electrônico	MPS [Monolithic Power Systems]

Página de início	http://www.monolithicpower.com

Logo

6 / 6 page

EV6534-U-00A EVB DESCRIPTION

NOTICE:

The information in this document is subject to change without notice. Users should warrant and guarantee that third

party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not

assume any legal responsibility for any said applications.

EV6534-U-00A Rev. 1.0

www.MonolithicPower.com

1/22/2016

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

QUICK START GUIDE

1. Attach the input voltage (5V ≤ VIN ≤ 55V) and input ground to the VIN and GND connectors

respectively.

2. Attach the logic power (3.3V or 5V) and logic power ground to the REN and REN_GND

connector.

3. Switch the SW1 to the position 1(Top side) to enable the chip.

4. Attach the OCP reference voltage (0.1V ≤ VREF ≤ 2V) to the OC_REF connector to set OCP

threshold.

5. Attach the hall signals coming from the motor to the Hall Sensor connector.

6. Attach the driving control signals generated by the external controller to the CN1 connector.

MP6534 Folha de dados(PDF) 6 Page - Monolithic Power Systems