EV6516-F-00A EVB DESCRIPTION

NOTICE:

The information in this document is subject to change without notice. Users should warrant and guarantee that third

party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not

assume any legal responsibility for any said applications.

EV6516-F-00A Rev. 1.0

www.MonolithicPower.com

5

10/9/2016

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2016 MPS. All Rights Reserved.

QUICK START GUIDE

respectively.

2. Input control and logic signal can be set either through the CN1 connector by the external MCU

or through the SW1 by manual action. Manual action requires an external 3.3V or 5V Vcc

voltage as a pull-up power supply. The logic truth table is shown in below:

ENx

OUTx

0

Z

0

Z

1

L

1

H

0

1

0

1

INx

3. The VISEN output voltage scaling is set by the RV1 adjustable resistor.