The X9119 integrates a single digitally controlled
potentiometer (XDCP™) on a monolithic CMOS integrated
circuit.
The digital controlled potentiometer is implemented using
1023 resistive elements in a series array. Between each
element are tap points connected to the wiper terminal
through switches. The position of the wiper on the array is
controlled by the user through the 2-wire bus interface. The
potentiometer has associated with it a volatile Wiper Counter
Register (WCR) and a four non-volatile Data Registers that
can be directly written to and read by the user. The contents
of the WCR controls the position of the wiper on the resistor
array though the switches. Powerup recalls the contents of
the default data register (DR0) to the WCR.
The XDCP™ can be used as a three-terminal potentiometer
or as a two terminal variable resistor in a wide variety of
applications including control, parameter adjustments, and
signal processing.

Features
• 1024 Resistor Taps – 10-Bit Resolution
• 2-Wire Serial Interface for Write, Read, and
Transfer Operations of the Potentiometer
• Wiper Resistance, 40Ω Typical @ VCC = 5V
• Four Non-Volatile Data Registers
• Non-Volatile Storage of Multiple Wiper Positions
• Power-on Recall. Loads Saved Wiper Position on
Power-up.
• Standby Current < 3µA Max
• VCC: 2.7V to 5.5V Operation
• 100kΩ End-to-End Resistance
• 100 yr. Data Retention
• Endurance: 100,000 Data Changes Per Bit Per Register
• 14 Ld TSSOP
• Low Power CMOS
• Single Supply Version of the X9118
• Pb-Free available (RoHS compliant)