|
1 Features
1• Supports ST-2082-1 (12G), ST-2081-1 (6G), ST-
424 (3G), ST-292 (HD), and ST-259 (SD)
• Compatible with DVB-ASI and AES10 (MADI)
• Integrated reclocker locks to SMPTE rates of
11.88 Gbps, 5.94 Gbps, 2.97 Gbps, 1.485 Gbps
or divide-by-1.001 sub-rates and 270 Mbps
• Integrated Eye Opening Monitor (EOM)
• Dual differential output cable drivers
• On-chip 75-Ω termination and return loss
compensation network
• Adaptive PCB input equalizer
• Reclocked 100-Ω loop-back output
• Automatic slew rate control on 75-Ω outputs
• Automatic pre-emphasis and output amplitude on
75-Ω outputs
• Programmable de-emphasis and output amplitude
on 100-Ω output
• Polarity inversion on 75-Ω and 100-Ω outputs
• Automatic power save in absence of input signal
– Power Consumption: 25 mW (Typical)
• Power-Down Control Through ENABLE Pin
• Single 2.5-V Supply
– Power consumption: 305 mW (typical)
• Programmable through pins, SPI, or SMBus
interface
• –40°C to +85°C operating temperature range
• 5-mm × 5-mm, 32-pin WQFN package
2 Applications
• SMPTE compatible serial digital interface
• UHDTV/4K/8K/HDTV/SDTV video
• Broadcast video routers, switchers, distribution
amplifiers, and monitors
• Digital video processing and editing
3 Description
LMH1228 device is a 12G UHD-SDI low power dual
output cable driver with integrated reclocker. It
supports SMPTE video rates up to 11.88 Gbps,
enabling UHD video for 4K/8K applications. With a
wide range clock-and-data recovery (CDR) circuit, the
on-chip reclocker automatically detects and locks to
all SMPTE video rates up to 11.88 Gbps. The
additional reclocked 100-Ω driver output on the hostside
can be used for monitoring or signal distribution
purposes.
The on-chip reclocker attenuates high-frequency jitter
and fully regenerates the data using a clean, low-jitter
clock. The reclocker has a built-in loop filter and does
not require any input reference clock. The LMH1228
also has an internal eye opening monitor and a
programmable pin for CDR lock indication, input
signal detect, or hardware interrupts to support
system diagnostics and board bring-up.
The LMH1228 is powered from a single 2.5-V supply.
It is offered in a small footprint 5 mm × 5 mm 32-pin
WQFN package. The LMH1228 is pin compatible with
the LMH1208 (12G Dual Cable Driver).
|