Features
• Simple single IC application board dedicated to VN9E30F
• Provides electrical connectivity and thermal heat-sinking for easy prototyping
• General device features
– Extreme low voltage operation for deep cold cranking applications (compliant with LV124, revision 2013)
– 24-bit ST-SPI for full diagnostic and digital current sense feedback
– Integrated 10-bit ADC for digital current sense
– Integrated PWM engine with independent phase shift and frequency generation (for each channel)
– Programmable Bulb/LED mode for all channels
– Advanced limp home functions for robust fail-safe system
– Very low standby current
– Optimized electromagnetic emissions
– Very low electromagnetic susceptibility
– Control through direct inputs and/or SPI
– Compliant with European directive 2002/95/EC
• Diagnostic functions
– Digital proportional load current sense
– Synchronous diagnostic of overload and short to GND, output shorted to VCC and OFF-state open-load
– Programmable case overtemperature warning
• Protections
– Two levels load current limitation
– Self limiting of fast thermal transients
– Undervoltage shutdown
– Overvoltage clamp
– Latch-off or programmable time limited auto restart (power limitation and overtemperature shutdown)
– Load dump protected
– Protection against loss of ground
– Reverse battery through self turn-on

Application
• Automotive resistive, inductive and capacitive loads

Description
The EV-VN9E30F board provides an easy way to connect ST VIPower M0-9SPI technology into existing system.