General Description
The 5T93GL02 2.5V differential clock buffer is a user-selectable
differential input to two LVDS outputs. The fanout from a differential
input to two LVDS outputs reduces loading on the preceding driver
and provides an efficient clock distribution network. The 5T93GL02
can act as a translator from a differential HSTL, eHSTL, LVEPECL
(2.5V), LVPECL (3.3V), CML, or LVDS input to LVDS outputs. A
single-ended 3.3V / 2.5V LVTTL input can also be used to translate
to LVDS outputs. The redundant input capability allows for a
glitchless change-over from a primary clock source to a secondary
clock source up to 450MHz. Selectable inputs are controlled by SEL.
During the switchover, the output will disable low for up to three clock
cycles of the previously-selected input clock. The outputs will remain
low for up to three clock cycles of the newly-selected clock, after
which the outputs will start from the newly-selected input. A FSEL
pin has been implemented to control the switchover in cases where
a clock source is absent or is driven to DC levels below the minimum
specifications.
The 5T93GL02 outputs can be asynchronously enabled/disabled.
When disabled, the outputs will drive to the value selected by the GL
pin. Multiple power and grounds reduce noise.

Features
• Guaranteed low skew: <50ps (maximum)
• Very low duty cycle distortion: <100ps (maximum)
• High speed propagation delay: <2.2ns (maximum)
• Up to 450MHz operation
• Selectable inputs
• Hot insertable and over-voltage tolerant inputs
• 3.3V/2.5V LVTTL, HSTL, eHSTL, LVEPECL (2.5V), LVPECL
(3.3V), CML or LVDS input interface
• Selectable differential inputs to two LVDS outputs
• Power-down mode
• At power-up, FSEL should be LOW
• 2.5V VDD
• -40°C to 85°C ambient operating temperature
• Available in TSSOP package
• Recommends IDT5T9302 if glitchless input selection is not
required
• Not Recommended for New Designs
• For functional replacement use 8SLVP1102