GENERAL DESCRIPTION
The ADuM4146 is a single-channel gate driver specifically optimized
for driving silicon carbide (SiC), metal-oxide semiconductor
field effect transistors (MOSFETs). Analog Devices, Inc., iCoupler®
technology provides isolation between the input signal and the
output gate drive.
The ADuM4146 includes a Miller clamp to provide robust SiC turn
off with a single-rail supply when the gate voltage drops to less
than 2 V. Operation with unipolar or bipolar secondary supplies is
possible with or without the Miller clamp operation.
The Analog Devices chip scale transformers also provide isolated
communication of control information between the high voltage and
low voltage domains of the chip. Information on the status of the
chip can be read back from dedicated outputs. Control of resetting
the device after a fault on the secondary side is performed on the
primary side of the device.
Integrated onto the ADuM4146 is a desaturation detection circuit
that provides protection against high voltage short-circuit SiC operation.
The desaturation protection contains noise reducing features,
such as a 300 ns masking time after a switching event to mask
voltage spikes due to initial turn on (see Figure 17). An optional
internal 500 μA current source allows low device count, and the
internal blanking switch allows the addition of an external current
source if more noise immunity is needed.
The secondary undervoltage lockout (UVLO) is set to 14.5 V (typical)
for Grade A and is set to 11.5 V (typical) for Grade B and
Grade C with common SiC and insulated gate bipolar transistor
(IGBT) levels taken into consideration.

FEATURES
► 11 A short-circuit source current (0 Ω gate resistance)
► 9 A short-circuit sink current (0 Ω gate resistance)
► 4.61 A peak current (2 Ω gate resistance)
► Output power device resistance: <1 Ω
► Output voltage range up to 30 V
► Multiple UVLO options on VDD2
► Grade A: 14.5 V (typical) UVLO on VDD2 positive going threshold
► Grade B and Grade C: 11.5 V (typical) UVLO on VDD2 positive
going threshold
► VDD1 input voltage range from 2.5 V to 6 V
► Desaturation protection
► Soft shutdown on desaturation fault
► Multiple desaturation detect comparator voltages
► Grade B: 9.2 V (typical)
► Grade A and Grade C: 3.5 V (typical)
► Miller clamp output with gate sense input
► Isolated fault and ready functions
► Low propagation delay: 75 ns (typical)
► Operating temperature range: −40°C to +125°C
► Creepage distance: 8.3 mm minimum
► CMTI: 100 kV/μs
► Safety and regulatory approvals (pending)
► 5000 V rms for 1 minute per UL 1577
► CSA Component Acceptance Notice 5A
► DIN V VDE V 0884-11
► VIORM = 2150 V peak

APPLICATIONS
► SiC/MOSFET/IGBT gate drivers
► Photovoltaic (PV) inverters
► Motor drives
► Power supplies