Os motores de busca de Datasheet de Componentes eletrônicos
  Portuguese  ▼
ALLDATASHEETPT.COM

X  

  • TSOP183..

  • AI
    The **TSOP1838** (often referred to simply as the 1838) is a miniaturized receiver for infrared (IR) remote control systems. It belongs to the TSOP (Thin Small Outline Package) family and is widely used in consumer electronics like TVs, air conditioners, and DIY projects with Arduino or Raspberry Pi. --- ## 1. Internal Functional Block Diagram The TSOP1838 is not just a phototransistor; it is an Integrated Circuit (IC) that includes several stages to process IR signals. | Stage | Function | | :--- | :--- | | **Photo Diode** | Converts IR light pulses into electrical signals. | | **Preamplifier** | Amplifies the weak electrical signal from the diode. | | **Automatic Gain Control (AGC)** | Adjusts sensitivity to filter out ambient light noise. | | **Band Pass Filter** | Passes only signals at a specific frequency (38kHz). | | **Demodulator** | Extracts the digital data from the 38kHz carrier wave. | --- ## 2. Technical Specifications Understanding the electrical limits is crucial for preventing hardware damage. | Parameter | Value | | :--- | :--- | | **Supply Voltage (Vcc)** | 2.7V to 5.5V | | **Carrier Frequency** | 38 kHz | | **Reception Distance** | Up to 18 meters | | **Reception Angle** | ± 45 degrees | | **Operating Current** | 0.35 mA to 0.6 mA | | **Output Type** | Active Low (Logic 0 when IR is detected) | --- ## 3. Pinout Configuration Looking at the sensor from the front (the side with the circular bump): 1. **Pin 1 (OUT):** The data output signal. Connects to a microcontroller digital pin. 2. **Pin 2 (GND):** The ground connection (0V). 3. **Pin 3 (VCC):** The power supply (typically 3.3V or 5V). --- ## 4. How it Works: The 38kHz Carrier The TSOP1838 is specifically tuned to a **38kHz** frequency. This is a form of noise immunity: * **Ambient Light:** Sunlight and light bulbs emit constant IR. The sensor ignores this. * **Modulated Light:** The IR LED in a remote control blinks 38,000 times per second. The TSOP1838 "sees" this blinking, filters it, and outputs a clean digital square wave to the microcontroller. --- ## 5. Typical Wiring Example To use the TSOP1838 with an Arduino, follow this structure: ```cpp // Example: Basic pin definition for TSOP1838 #define IR_RECEIVER_PIN 2 void setup() { Serial.begin(9600); pinMode(IR_RECEIVER_PIN, INPUT); } void loop() { int signal = digitalRead(IR_RECEIVER_PIN); if (signal == LOW) { // IR Signal Detected Serial.println("IR Signal Received!"); } } ``` ---
    ✨ Follow-up Questions
    • ⤷What is the difference between the TSOP1838 and the TSOP4838?
    • ⤷ How do I add a filter circuit to improve signal stability?
    • ⤷ Can a TSOP1838 receive signals from a 40kHz remote?