M9366-RDS6T
AI

The **M9366-RDS6T** (commonly identified within the **M93C66** series) is a 4-Kbit serial Microwire EEPROM (Electrically Erasable Programmable Memory) manufactured by STMicroelectronics. It is designed for low-power applications requiring non-volatile storage.
---
## 1. Technical Specifications
Below is a summary of the core electronic parameters for the M9366-RDS6T:
| Parameter | Value / Specification |
| :--- | :--- |
| **Memory Size** | 4 Kbit (4096 bits) |
| **Organization** | 256 x 16-bit or 512 x 8-bit (Selectable) |
| **Interface** | Microwire (3-Wire Serial) |
| **Operating Voltage** | 1.8V to 5.5V |
| **Clock Frequency** | 2 MHz (at 5V) |
| **Package Type** | TSSOP8 (Thin Shrink Small Outline Package) |
| **Operating Temp** | -40°C to +85°C (Industrial Grade) |
| **Endurance** | 1 Million Write Cycles |
| **Data Retention** | 40 Years |
---
## 2. Pin Configuration (TSSOP8)
The device typically follows the standard Microwire pinout for 8-pin packages:
| Pin Number | Symbol | Description |
| :--- | :--- | :--- |
| 1 | **S** | Chip Select (Active High) |
| 2 | **C** | Serial Clock |
| 3 | **D** | Serial Data Input |
| 4 | **Q** | Serial Data Output |
| 5 | **Vss** | Ground |
| 6 | **ORG** | Organization Select (x8 or x16) |
| 7 | **DU** | Don't Use / No Connect |
| 8 | **Vcc** | Supply Voltage |
---
## 3. Key Electronic Features
### Microwire Interface
Unlike I2C or SPI, Microwire uses a specific 3-wire synchronous protocol (plus a Chip Select). It is highly efficient for simple microcontrollers that lack dedicated hardware peripherals for more complex buses.
### Sequential Read
The M9366 supports sequential reading, allowing the master to read the entire memory contents by continuing to provide clock pulses after the initial address is sent.
### Write Protection
The device includes a **Write Enable (WEN)** and **Write Disable (WDS)** instruction set. This provides software-based protection against accidental data corruption during power-up or power-down cycles.
### Organization Select (ORG Pin)
The memory architecture is flexible:
* **ORG connected to Vcc:** Memory is organized as 256 words of 16 bits.
* **ORG connected to Vss:** Memory is organized as 512 bytes of 8 bits.
---
## 4. Typical Applications
* **Consumer Electronics:** Storing user preferences in TVs or set-top boxes.
* **Automotive:** Storing calibration data or odometer information (AEC-Q100 versions available).
* **Industrial:** Configuration settings for sensors and actuators.
* **Computing:** Basic Input/Output System (BIOS) parameters and ID storage.
- ⤷
How does the Microwire protocol differ from the SPI protocol?
- ⤷ What are the specific timing requirements for the 'S' (Chip Select) pin?
- ⤷ Can you explain the power-on reset (POR) threshold for this device?