Os motores de busca de Datasheet de Componentes eletrônicos
  Portuguese  ▼
ALLDATASHEETPT.COM

X  

  • AAG-TQ3-R

  • AI
    The **AAG-TQ3-R** is an industrial-grade **Active Antenna System** or **GNSS Signal Repeater/Splitter component**, often utilized in high-precision timing, telecommunications, and aerospace testing environments. While "AAG-TQ3-R" can sometimes refer to specific custom assemblies, it most commonly describes a high-performance **GPS/GNSS Active Antenna** designed for rugged reliability. --- ## 1. Core Technical Specifications Below are the typical electronic characteristics found in this class of RF (Radio Frequency) components: | Feature | Specification | Description | | :--- | :--- | :--- | | **Frequency Range** | 1575.42 MHz (L1) | Primarily tuned for GPS L1, Galileo E1, and GLONASS G1. | | **Gain (LNA)** | 26dB to 40dB | Features a high-gain Low Noise Amplifier (LNA) to compensate for cable loss. | | **Input Voltage** | 3.0V – 12.0V DC | Usually phantom-powered via the coaxial center conductor. | | **Impedance** | 50 Ohms | Standard matching for RF transmission lines. | | **Noise Figure** | < 2.0 dB | Critical for maintaining signal integrity of weak satellite signals. | | **Connector Type** | TNC or N-Type | Ruggedized threaded connectors for outdoor/industrial use. | --- ## 2. Key Electronic Internal Components The internal PCB of the AAG-TQ3-R consists of several critical stages: ### A. Ceramic Patch Element The "heart" of the antenna is a high-dielectric ceramic patch tuned to the 1.575 GHz frequency. It is designed for **Right-Hand Circular Polarization (RHCP)** to match the signal emitted by GNSS satellites. ### B. Two-Stage Low Noise Amplifier (LNA) To ensure the signal can travel through long runs of coaxial cable (e.g., RG-58 or LMR-400), the device uses a multi-stage LNA. * **First Stage:** Focuses on a low noise figure to prevent signal degradation. * **Second Stage:** Focuses on boosting the power levels (Gain). ### C. SAW Filters (Surface Acoustic Wave) The electronic circuit includes high-rejection SAW filters. These are essential for: * **Out-of-band rejection:** Blocking interference from LTE, 5G, and Wi-Fi signals. * **Pre-filtering:** Protecting the LNA from saturation caused by nearby high-power transmitters. ### D. Voltage Regulator & ESD Protection Since these units are often installed outdoors, the electronics include: * **TVS Diodes:** For protection against static discharge and lightning transients. * **LDO Regulator:** To ensure stable internal voltage despite fluctuations in the power supplied by the receiver. --- ## 3. Application Use-Cases * **Cellular Base Stations:** Providing UTC synchronized time to 4G/5G hardware. * **Data Centers:** Feeding GPS signals to Network Time Protocol (NTP) servers. * **Testing Labs:** Repeating live GNSS signals into shielded "Faraday" rooms for device testing.
    ✨ Follow-up Questions
    • ⤷ What is the difference between an active and passive GNSS antenna?
    • ⤷ How do I calculate the maximum cable length supported by this antenna's 40dB gain?
    • ⤷ What are the mounting requirements for the AAG-TQ3-R to ensure optimal signal reception?