Instruction Sheet

Mass Termination Assembly (MTA)

Applicator Assemblies

408--4260

LOC B

1

of 7

E

2010 Tyco Electronics Corporation, Berwyn, PA

All Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.

TOOLING ASSISTANCE CENTER 1--800--722--1111

PRODUCT INFORMATION 1--800--522--6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

02 AUG 10 Rev D

58575- 1 and 58576- 1

SAFETY PRECAUTIONS AVOID INJURY

Safeguards are designed into this application equipment to protect operators and maintenance personnel from

most hazards during equipment operation. However, certain safety precautions must be taken by the operator

and repair personnel to avoid personal injury, as well as damage to the equipment. For best results, application

equipment must be operated in a dry, dust--free environment. Do not operate equipment in a gaseous or

hazardous environment.

Carefully observe the following safety precautions before and during operation of the equipment:

D

ALWAYS wear appropriate ear protection.

D

ALWAYS wear approved eye protection when operating powered equipment.

D

ALWAYS keep guard(s) in place during normal operation.

D

ALWAYS disconnect the tool from its power source when performing maintenance on the equipment.

D

NEVER wear loose clothing or jewelry that may catch in moving parts of the application equipment.

D

NEVER insert hands into installed application equipment.

D

NEVER alter, modify, or misuse the application equipment.

TOOLING ASSISTANCE CENTER

The Tooling Assistance Center offers a means of providing technical assistance when required.

In addition, Field Service Specialists are available to provide assistance in the adjustment or repair of the

application equipment when problems arise which your maintenance personnel are unable to correct.

INFORMATION REQUIRED WHEN CONTACTING THE TOOLING ASSISTANCE CENTER

When calling the Tooling Assistance Center regarding service to equipment, it is suggested that a person

familiar with the device be present with a copy of the manual (and drawings) to receive instructions. Many

difficulties can be avoided in this manner.

When calling the Tooling Assistance Center, be ready with the following information:

10. Additional information/comments that may be helpful

DANGER