408-4217

PRO-CRIMPER III Hand Crimping Tool Assembly 318451-1

5 of 5

Rev B

Tyco Electronics Corporation

7. MAINTENANCE

Ensure that the tool and dies are clean by wiping

them with a clean, soft cloth. Remove any debris with

a clean, soft brush. Do not use objects that could

damage the tool. When not in use, keep handles

closed to prevent objects from becoming lodged in

the crimping dies, and store in a clean, dry area.

8. REPLACEMENT

Customer–replaceable parts and dies are shown in

Figure 8. Spare parts or the die assembly should be

stocked and controlled to prevent lost time when die

replacement is necessary.

Available separately, PRO–CRIMPER III Hand

Crimping Tool Repair Kit 679221–1 includes a

replacement nut and a variety of pins, rings, screws,

and springs.

Order replaceable parts through your Tyco

Electronics Representative, or call 1–800–526–5142,

or send a facsimile of your purchase order to

1–717–986–7605, or write to:

CUSTOMER SERVICE (38–35)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105–3608

For customer repair service, contact a Tyco

Electronics Representative at 1–800–526–5136.

9. REVISION SUMMARY

Since the previous release of this instruction sheet,

the following change were made:

corporate requirements.

g1.04-1.17

[.041-.046]

2.64 +0.20

[.104 +.008]

4.32 +0.10

[.170 +.004]

47.62

[1.88]

11.63

[.458]

Weight: 227 g [8 oz]

1

2

3

4

5

gOne side can go 0.064 [.0025] out of tolerance as long as the average

measurements of both sides are within dimension specified.

CUSTOMER-REPLACEABLE PARTS FOR DIE ASSEMBLY 318451-2

ITEM

PART NUMBER

DESCRIPTION

QTY PER

ASSEMBLY

1

318432-1

INDENTER, Wire

1

2

318430-1

ANVIL, Wire

1

3

318431-2

INDENTER, Insulation

1

4

318429-2

ANVIL, Insulation

1

5

679231-1

PIN, Die Retaining

4

Figure 8