ATmega32HVB datasheet(221/273 Pages) ATMEL

Nome de Peças	ATmega32HVB

Descrição Electrónicos	8-bit Microcontroller with 16K/32K Bytes In-System Programmable Flash

PDF	273 Pages

Scroll/Zoom	100%

Fabricante Electrônico	ATMEL [ATMEL Corporation]

Página de início	http://www.atmel.com

Logo

221 / 273 page

221

8042A–AVR–07/09

ATmega16HVB/32HVB

Figure 30-5. Programming the Flash Waveforms

(1)

Note:

1. “XX” is don’t care. The letters refer to the programming description above.

30.7.6

Programming the EEPROM

The EEPROM is organized in pages, see Table 30-8 on page 211. When programming the

EEPROM, the program data is latched into a page buffer. This allows one page of data to be

programmed simultaneously. The programming algorithm for the EEPROM data memory is as

follows (refer to ”Programming the Flash” on page 219 for details on Command, Address and

Data loading):

A: Load Command “0001 0001”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

C: Load Data (0x00 - 0xFF).

E: Latch data (give PAGEL a positive pulse).

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

Set BS to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page (See Figure 30-6 for

signal waveforms).

RDY/BSY

RESET +12V

PAGEL

BS2

0x10

ADDR. LOW

ADDR. HIGH

DATA

DATA LOW

DATA HIGH

ADDR. LOW

DATA LOW

DATA HIGH

XA1

XA0

BS1

XTAL1

ATmega32HVB Folha de dados(PDF) 221 Page - ATMEL Corporation

ATmega32HVB Folha de dados(HTML) 221 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL