H8SLASH3028F datasheet(135/923 Pages) RENESAS

Nome de Peças	H8/3028F

Descrição Electrónicos	Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

PDF	923 Pages

Scroll/Zoom	100%

Fabricante Electrônico	RENESAS [Renesas Technology Corp]

Página de início	http://www.renesas.com

Logo

135 / 923 page

Rev. 2.00, 09/03, page 105 of 890

5.5

Usage Notes

5.5.1

Contention between Interrupt and Interrupt-Disabling Instruction

When an instruction clears an interrupt enable bit to 0 to disable the interrupt, the interrupt is not

disabled until after execution of the instruction is completed. If an interrupt occurs while a BCLR,

MOV, or other instruction is being executed to clear its interrupt enable bit to 0, at the instant

when execution of the instruction ends the interrupt is still enabled, so its interrupt exception

handling is carried out. If a higher-priority interrupt is also requested, however, interrupt exception

handling for the higher-priority interrupt is carried out, and the lower-priority interrupt is ignored.

This also applies to the clearing of an interrupt flag to 0.

Figure 5.8 shows an example in which an IMIEA bit is cleared to 0 in the 16-bit timer's TISRA

IMIA exception handling

TISRA write cycle by CPU

TISRA address

Internal

address bus

Internal

write signal

IMIEA

IMIA

IMFA interrupt

signal

Figure 5.8 Contention between Interrupt and Interrupt-Disabling Instruction

This type of contention will not occur if the interrupt is masked when the interrupt enable bit or

flag is cleared to 0.

H8/3028F Folha de dados(PDF) 135 Page - Renesas Technology Corp