R8C2K datasheet(413/471 Pages) RENESAS

413 / 471 page

R8C/2K Group, R8C/2L Group

20. Flash Memory

Rev.1.10

Dec 21, 2007

Page 396 of 450

REJ09B0406-0110

20.7

Notes on Flash Memory

20.7.1

CPU Rewrite Mode

20.7.1.1

Operating Speed

Before entering CPU rewrite mode (EW0 mode), select 5 MHz or below for the CPU clock using the CM06 bit

in the CM0 register and bits CM16 to CM17 in the CM1 register. This does not apply to EW1 mode.

20.7.1.2

Prohibited Instructions

The following instructions cannot be used in EW0 mode because they reference data in the flash memory:

UND, INTO, and BRK.

20.7.1.3

Non-Maskable Interrupts

• EW0 Mode

Once a watchdog timer, oscillation stop detection, voltage monitor1, or voltage monitor 2 interrupt request

is acknowledged, auto-erasure or auto-programming is forcibly stopped immediately and the flash memory

is reset. Interrupt handling starts after a fixed period and the flash memory restarts.

As the block during auto-erasure or the address during auto-programming is forcibly stopped, the normal

value may not be readable. Execute auto-erasure again and ensure it completes normally.

The watchdog timer does not stop during command operation, so that interrupt requests may be generated.

Initialize the watchdog timer regularly.

Do not use the address match interrupt while a command is being executed because the vector of the

address match interrupt is allocated in ROM.

Do not use a non-maskable interrupt while block 0 is being automatically erased because the fixed vector is

allocated in block 0.

• EW1 Mode

Once a watchdog timer, oscillation stop detection, voltage monitor1, or voltage monitor 2 interrupt request

is acknowledged, auto-erasure or auto-programming is forcibly stopped immediately and the flash memory

is reset. Interrupt handling starts after a fixed period and the flash memory restarts.

As the block during auto-erasure or the address during auto-programming is forcibly stopped, the normal

value may not be readable. Execute auto-erasure again and ensure it completes normally.

The watchdog timer does not stop even during command operation, so that interrupt requests may be

generated. Initialize the watchdog timer by using the erase-suspend function.

Do not use the address match interrupt while a command is being executed because the vector of the

address match interrupt is allocated in ROM.

Do not use a non-maskable interrupt while block 0 is being automatically erased because the fixed vector is

allocated in block 0.

R8C2K Folha de dados(PDF) 413 Page - Renesas Technology Corp

R8C2K Folha de dados(HTML) 413 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL