1. Product Overview:

️· Product Type: SMT (Surface Mount Technology) Inductors. This means they are designed to be soldered directly onto a circuit board.
️· Series: AISC-0805LP (This is the main product identifier)

2. Key Features and Specifications (From the Tables):


️· Inductance Values (Examples – there are many different values): 0.8uH, 1.0uH, 1.5uH, 3.0uH. (Values are in microhenries, μH)
️· Tolerance: ±2% (G), ±5% (J), ±10% (K). This indicates the allowable variation from the stated inductance value.
️· Saturation Current (Isat): Values exist from 6.0A to 8.0A. This is the current at which the inductor's inductance starts to significantly decrease.
️· Rated Current (Irms): Values around 5.3A to 6.0A. This is the current the inductor can handle continuously without excessive heating.
️· Quality Factor (Q): Values are around 5.0 to 8.0
️· SRF (Self-Resonant Frequency): Values ranging from 3.0MHz to 8.0MHz.
️· Packaging: Tape & Reel (2000 pieces per reel)
️· Dimensions: 0.8mm x 2.3mm
️· Physical Characteristics:
- Height: 0.9mm
- Spacing: 4mm
- Width: 1.5mm
- Weight: Unknown from the datasheet
️· Operating Temperature: Not explicitly stated, but implied to be standard electronics operating range.
️· Test Equipment Used: HP4291B Impedance Analyzer, GOM-801G Micro-ohm Meter, HP8753 Network Analyzer. (This confirms the accuracy of the published specifications)

3. Part Identification & Ordering Information:

️· AISC-0805LP - X - Y This is the key to understanding the part number structure.
- AISC-0805LP: The base series.
- X: Inductance Code. (This is a code that corresponds to the specific inductance value. The datasheet doesn't provide a direct translation of the code to the inductance, but it's crucial for ordering.)
- Y: Tolerance Code (G, J, K – as defined above).

4. Important Notes & Restrictions:

️· Standard Use: These inductors are designed for general commercial and industrial applications.
️· High-Reliability Applications: If you require the inductors for applications with high-reliability requirements (e.g., aerospace, medical), you *must* obtain written authorization from ABRACON.

5. Outlines Drawing:
️· 0.8mm x 2.3mm x 0.9mm
️· Pin pitch 4mm
️· Weight Unknown

How to Use This Information:

️· Determine the Inductance: Find the inductance code (X) in the table or product listing.
️· Specify Tolerance: Choose the tolerance code (Y) that meets your application's accuracy requirements.
️· Check Current Ratings: Ensure the Saturation Current (Isat) and Rated Current (Irms) are adequate for your circuit.
️· Contact ABRACON: If you have any doubts or need to customize the inductor, contact ABRACON directly.