Important Notes & Considerations:

️· Supply Voltage (Vcc): The data sheets present specs at *both* 5V and 2V supply voltages. Pay very close attention to this as performance changes significantly.
️· Typical vs. Guaranteed: The tables specify “Min,” “Typ,” and “Max” values. “Typ” values are typical performance based on testing, but are *not* guaranteed in production. “Min” and “Max” are the guaranteed limits. The last pages contain typical performance graphs which give more information.
️· Load Conditions: Many parameters are tested with a specific load resistance (RL) and capacitance (CL) - typically RL = 10kΩ and CL = 47pF.
️· Two sets of data: There are slight variations between the first three pages and the following pages. The last set of pages present data at 5V and 2V, but also include some additional tests and graphs.
️· Overload Recovery Time: There is a discrepancy for this spec: 200ns versus 250ns
️· Slew Rate: There is a discrepancy for this spec: 13-17 V/us versus 17-23 V/us
️· THD+N: There is a discrepancy for this spec: 0.004% versus 0.005%

1. DC Characteristics (Parameters measured with DC signals)

Parameter	Symbol	Condition	Min	Typ	Max	Notes
Supply Voltage	Vcc		1.8V	5V	5.5V
Supply Current	Icc		-	3-3.4 mA	-	at Vcc = 5V, Vicm = 0V
Input Offset Voltage	Vio		-5mV	-1mV	5mV	at Vcc = 5V, Room Temp.
Input Offset Voltage Thermal Drift	dVio/dT		-	50uV/°C	-
Input Bias Current	Ib		-	-	-

2. AC Characteristics (Parameters measured with AC signals)

Parameter	Symbol	Condition	Min	Typ	Max	Notes
Gain Bandwidth Product	GBP	RL = 10kΩ	23 MHz	30 MHz	-
Slew Rate	SR	RL = 10kΩ, Av = 1	13 V/µs	17 V/µs	23 V/µs	Vcc = 5V
Overload Recovery Time	t_rec	Vout 100mV from rail	200 ns	250 ns	-
THD+N	THD+N	Vin = 1Vpp, RL = 10kΩ	-	0.004-0.005%	-	Av = 1, f = 1kHz, BW = 22kHz
Phase Margin	Φm		50°	-	-

3. Input/Output Characteristics

Parameter	Symbol	Condition	Min	Typ	Max	Notes
High-Level Output Voltage	VOH		-	-	-
Low-Level Output Voltage	VOL		-	-	-
Output Current (Sink)	Iout_sink		45mA	51mA	-	Vcc = 5V
Output Current (Source)	Iout_source		45mA	56mA	-	Vcc = 5V

4. Other Parameters

Parameter	Symbol	Condition	Min	Typ	Max	Notes
Input Voltage Noise Density	en	f = 10kHz	-	13nV/√Hz	-
Input Capacitance (Differential)	Cin_diff		-	6.3pF	-
Input Capacitance (Common Mode)	Cin_cm		-	1.6pF	-

Important Considerations when Using This Data:

️· Operating Conditions: Always ensure your application's operating conditions (supply voltage, temperature, load) are within the specified ranges.
️· Layout: Proper PCB layout is crucial for high-performance op-amp applications. Minimize stray capacitance and inductance.